40 Molds Pizza Cone Making Machine

The Pizza Cone Making Machine is divided into upper and lower die, die by the temperature control knob when the temperature is well adjusted first, the temperature rises to pull the mold closed into paste, then upper die and a lower die, about one to two minutes after the cone forming, die drawing mould open, cone will automatically fall into the following passage and a slide out.

When operating, should following these steps:
1. Heating temperature setting: the heating temperature can be adjusted form 0~250C.
2. Indicator light: the indicator light is shining when the temperature of code rod in the mould is not enough during heating.
3. Power supply indicator light (L-Power supply): the power indicator light is shining when the power supply is enough.
4. Emergency stop: press it to stop the machine working at any time.
5. Rise: press it to rise up the upper mould.
6. Start / Drop down: Set up the heating time with time replay at first, press Start button, the upper mould will drop down to the lower mould automatically. When heating time is finished, the upper mould will rise up from the lower mould automatically, and there is buzzer happened at the same time.
7. Anticreeping switch: when the machine current is out of standard, the button will show out, press this button to reset the motor.
(notes: during the machine working, press Emergency stop button to operate the machine only)